InstructionsSaw, cut and then check the sizesSaw the pickets 2 3/4" wide, then cut the peak on each one using a mitre saw set 35º from square before cutting to the final length of 14". The angle of each picket tip should measure 110º. Cut the two rails to size, then mark locations for the peg holes on the front surfaces. The top rail pegs are 6" from the ends, while the bottom rail pegs are 2" from each end with one more peg in the middle. This leaves 8" between the bottom pegs. Check the size of the holes needed for the pegs you have on hand before you drill. Size does vary. My pegs needed 1/2"-diameter holes, 1/2" deep. Assembly
Assembly comes next, but before you begin, rout a 1/8"-wide, 45º chamfer on all edges, then sand the entire project with 120-grit paper. Next, place the rails face down on a flat surface, then find a 4 1/2"-wide piece of scrap wood to use as a spacer. Put it between each rail, then begin placing pickets on top.
Use two #8 x 1 1/2" screws to secure each picket-to-rail joint. Notice on the plans that the rails extend 5/8" proud of the edges of the outer pickets. The picket bottom ends are 1 1/2" proud of the bottom rail, with a 1 1/4" space between pickets. The finishing touchesAny type of clear outdoor finish will work well on the rack. I chose to paint the pegs satin black. For those who enjoy folk-art painting, this project makes a great outdoor canvas. When your finish is dry, apply weatherproof glue and tap the pegs in place. Mount your rack anywhere you like. No matter where it goes, it'll soon be full! |
|
Export date: Sat Nov 23 11:58:49 2024 / +0000 GMT This page was exported from Canadian Home Workshop [ https://canadianhomeworkshop.com ] |
